Skip to content

This is general guidance based on standard permitted development rights in England. Rules differ for listed buildings, conservation areas, and properties with Article 4 directions. Always confirm with your local planning authority before starting work.

Usually Permitted DevelopmentCannock Chase (West Midlands)

Do I Need Planning Permission for a Flue or Extraction System in Cannock Chase?

Installing a flue, chimney, or extraction system on your property (for example, for a kitchen extractor, boiler, or stove). The permitted development rules are the same as for new chimney/flue installation.

Planning in Cannock Chase

91%

of planning applications granted

96%

decided within the statutory or agreed time

82%

of householder applications decided within 8 weeks

In the four quarters to 2026 Q1, Cannock Chase decided 242 planning applications. 124 of these were householder projects such as extensions, loft conversions and outbuildings, of which 93% were granted.

Planning statistics: MHCLG planning application statistics, the four quarters to 2026 Q1. Conservation area and Article 4 data: planning.data.gov.uk, © Historic England / Crown copyright. Open Government Licence v3.0.

Important: Additional Restrictions May Apply in Cannock Chase

Cannock Chase has 8 conservation areas. These include Brereton Conservation Area, Bridgtown North Street Conservation Area, Cannock Town Centre Conservation Area, Rugeley Church Street Conservation Area, Rugeley Town Centre Conservation Area, Sheepfair/Bow Street Conservation Area. If your property is in a conservation area, some or all permitted development rights may be restricted. For example, you may need planning permission for changes that would normally be permitted, including alterations to the roof, cladding, or extensions visible from a public highway.

Cannock Chase has 6 recorded Article 4 directions. These include Burial Ground. Article 4 directions remove specific permitted development rights in defined areas. If your property is covered by an Article 4 direction, you may need planning permission for work that would normally be permitted. Contact Cannock Chase planning department to check whether an Article 4 direction applies to your property.

Check with Cannock Chase planning department before starting work to confirm whether your property is affected by any special designations.

Permitted Development Rules for a Flue or Extraction System

Generally permitted under Part 1, Class G of the GPDO. One flue, chimney, or soil and vent pipe is permitted on a dwelling provided it does not exceed the highest part of the roof by more than 1 metre. The flue must not be on the principal elevation in designated areas.

Conditions

  • 1Must not exceed the highest part of the roof by more than 1m
  • 2Only one flue per dwelling under PD
  • 3Must not be on the principal elevation or side elevation fronting a highway in designated areas
  • 4Kitchen extraction: external vent or ducting follows the same rules
  • 5Must comply with clean air legislation if for a combustion appliance

Size and Dimension Limits

  • Must not exceed the highest part of the roof by more than 1m
  • One flue only under PD

When Permitted Development Does Not Apply

  • Listed buildings require listed building consent
  • In conservation areas, position and appearance restrictions apply
  • Odour and noise from extraction systems can be a statutory nuisance
  • Additional flues beyond the first require planning permission

What About Building Regulations?

Building regulations approval is likely required

Building Regulations apply if the flue or extraction system serves a combustion appliance (Part J). Kitchen and bathroom extraction must comply with Part F (ventilation). Gas flues must be installed by a Gas Safe registered engineer. A HETAS-registered installer can self-certify solid fuel installations.

Building regulations are separate from planning permission. Even if your project is permitted development, you may still need building regulations approval. Contact Cannock Chase building control or use an approved inspector.

How to Apply in Cannock Chase

If you need planning permission for your flue or extraction system, you can apply through Cannock Chase's planning department or via the national Planning Portal.

Timeline:8 weeks for householder planning applications if PP is needed.
Cost:£258
Visit Cannock Chase Planning

If your project is permitted development and you want written confirmation, you can apply for a Lawful Development Certificate (LDC) from Cannock Chase. This provides proof that your project does not need planning permission, which can be helpful when selling your property.

What Happens If I Build Without Permission?

Low risk for standard domestic flues within PD limits. Extraction systems that cause odour or noise nuisance to neighbours are more likely to be addressed under environmental health legislation than planning enforcement.

Frequently Asked Questions

Do I need planning permission for a flue or extraction system in Cannock Chase?
Generally permitted under Part 1, Class G of the GPDO. One flue, chimney, or soil and vent pipe is permitted on a dwelling provided it does not exceed the highest part of the roof by more than 1 metre. The flue must not be on the principal elevation in designated areas. Note: Cannock Chase has 8 conservation areas (including Brereton Conservation Area, Bridgtown North Street Conservation Area, Cannock Town Centre Conservation Area) and 6 recorded Article 4 directions where permitted development rights may be restricted. Check with Cannock Chase planning department.
Does a flue or extraction system in Cannock Chase need building regulations?
Yes. Building Regulations apply if the flue or extraction system serves a combustion appliance (Part J). Kitchen and bathroom extraction must comply with Part F (ventilation). Gas flues must be installed by a Gas Safe registered engineer. A HETAS-registered installer can self-certify solid fuel installations. Contact Cannock Chase building control or an approved inspector for details.
How do I apply for planning permission in Cannock Chase?
You can apply for planning permission through Cannock Chase's planning department or via the national Planning Portal. £258. 8 weeks for householder planning applications if PP is needed..
How long does planning permission take in Cannock Chase?
Most planning applications should be decided within 8 weeks (13 weeks for major projects). In the four quarters to 2026 Q1, Cannock Chase decided 96% of applications within the statutory or agreed time, and 82% of householder applications within 8 weeks.
What percentage of planning applications does Cannock Chase approve?
Cannock Chase granted 91% of the 242 planning applications it decided in the four quarters to 2026 Q1. For householder applications such as extensions and outbuildings, the approval rate was 93%.

Find a Builder in Cannock Chase

Browse local builders on Tradesfolk. Read reviews, compare quotes, and hire with confidence. 100% free for homeowners, always.

Flue or Extraction System rules in nearby council areas

Other projects in Cannock Chase

Help us improve Tradesfolk

Found a bug or have an idea? Tell us what would make Tradesfolk more useful for you.

For bugs, tell us what you were trying to do and what went wrong.

Add this if you would like us to reply.

Page included with your feedback:

Sent to hello@tradesfolk.co